Design, basic theory and calculation of car.
The textbook is written in accordance with the program of the same name of course. The book describes the General provisions on purpose, structure and effect of major parts, systems and mechanisms of a vehicle for example car design, the most common in the national economy (""Volga"" GAZ-24, GAZ-53, ZIL-130, MAZ-500), and only in some cases, the designs of the original parts of the vehicle other models.
The most important dimensions of parts are determined or specified by the calculation associated with the functional purpose of a part or are performed to provide the necessary strength, stiffness or durability of the part. The textbook used the most simple method of estimating these parameters is based on comparing actual stresses with the allowable stresses. It allows for the design to focus on the tension parts are proven designs that work in about the same conditions, and thereby use the experience of the automotive industry.
In presenting the fundamentals of theory and calculation of applied SI units. With sufficient for practical calculations, the accuracy is assumed that 1 kg ~ 10 N. Elastic modulus, ultimate strength, yield strength and toughness of materials, voltage, and pressure are expressed in megapascal (MPa) and are rounded to the nearest 1 MPa = 10 kgf/cm2. The correlations between the other SI units and other are given in table. 1.
In some cases the quantities involved in formulas are expressed in decimal fraction or multiple of units. These deviations are stipulated, except when the reader can understand the units applied units.
Terms and symbols relating to the geometry and kinematics of gears, applicable standards (GOST 16530-70 and 16532-70).

Publisher: engineering/DjVu (fully recognized)+DOC